SlackWare 12.0 Dont find SATA drive.

  • anybody2k
  • Born
  • Born
  • anybody2k
  • Posts: 1

Post 3+ Months Ago

this213 wrote:
there's a little tiny jumper on 4 pins on the back of the hard drive. If it's a SATA 2 drive, you DEFINITELY NEED to have that set to jump the left two pins (if looking at the side the pins are on with the label up). I'm really not even sure of how your board is reading that drive, but if it's in 3.0 mode, CR205 (behind the data pins on the drive's controller board) is well known (by me) to flat out blow if connected to a 1.5 port (I've seen no less than a dozen instances first hand).


Haha, my CR205 blew yesterday upon connecting the drive to my computer (Intel ICH9R Controller), Jumper was set over the left 2 pins however. I have no clue why this happened :lol:
  • Anonymous
  • Bot
  • No Avatar
  • Posts: ?
  • Loc: Ozzuland
  • Status: Online

Post 3+ Months Ago

Post Information

  • Total Posts in this topic: 31 posts
  • Users browsing this forum: No registered users and 60 guests
  • You cannot post new topics in this forum
  • You cannot reply to topics in this forum
  • You cannot edit your posts in this forum
  • You cannot delete your posts in this forum
  • You cannot post attachments in this forum
 
cron
 

© 1998-2014. Ozzu® is a registered trademark of Unmelted, LLC.